Kleindiek LCMK low current measurement kit
The LCMK-EM is a low-resistance, low-noise probe tip holder for the MM3A-EM or MM3E micromanipulator. It enhances your system’s nanoprobing capability by allowing low-capacity, low-current measurements on conductive specimens.
Standard tungsten probe tips can be inserted into the front of the LCMK-EM tip holder. Triax cabling and feedthroughs carry signals through to a connector which fits all conventional parameter analysers.
In addition to the standard version for SEM/FIB it is also available in versions for UHV, high temperature, low temperature and life sciences.
Applications:
- failure analysis
- qualification of high к gate materials
- low-current transistor measurement
- EBIC/RCI analysis
- electrical characterization of advanced materials e.g. nanowires, ultra-thin films
Standard version Part number PL-LCMK1-000
A plug-in tool for the MM3A-EM or MM3E to allow low-current, low-capacity measurements on conductive samples. Each kit consists of a probe tip holder, vacuum and air-side triax cabling and a vacuum feedthrough. A vacuum flange and an operator’s handbook is also included with each delivery. One kit required per MM3A or MM3E.
- Current measurement limit: 3 fA @ 1 Hz
- Insulation leakage current: 50 fA at 1 V
- Signal conductor resistance: 0.9 Ω
- Maximum voltage: ±210 V
- Maximum current: 200 mA
- Maximum frequency: 100 MHz
All technical specifications are approximate. Due to continuous development, we reserve the right to change specifications without notice.
Ordering information:
Kleindiek LCMK low current measurement kit plug-in tool
The LCMK is available in various versions for EM, UHV applications
-
Cryo low current measurement kit
Cryo Low-Current measurement Kit – A plug-in tool for the MM3A-EM to allow low-current- low-capacity measurements on conductive samples in a cryo environment. Each kit consists of a probe tip holder- vacuum and air-side triax cabling and a vacuum feedthrough. A vacuum flange and an operator’s handbook is also included with each delivery. One kit required per MM3A.
Price On Request £0.00 Add to basket -
Low current measurement kit for UHV
A plug-in tool for the MM3A-UHV to allow low-current, low-capacity measurements on conductive samples in UHV chambers. Each kit consists of a probe tip holder and cabling according to the UHV chamber specification. An operator’s handbook is also included with each delivery. One kit required per MM3A-UHV.
Price On Request £0.00 Add to basket -
Thermally Insulated low-current measurement kit
A plug-in tool for the MM3A-EM to allow low-current, low-capacity measurements on conductive samples with a temperature of up to 200° C. Each kit consists of a probe tip holder, vacuum and air-side triax cabling and a vacuum feedthrough. A vacuum flange and an operator’s handbook is also included with each delivery. One kit required per MM3A.
Price On Request £0.00 Add to basket -
Low-current measurement Kit
Low-Current measurement Kit – A plug-in tool for the MM3A-LMP to allow low-current- low-capacity measurements on conductive samples. Each kit consists of a probe tip holder- triax cabling and an operator’s handbook. One kit required per MM3A.
Price On Request £0.00 Add to basket -
Low current measurement kit
A plug-in tool for the MM3A-EM to allow low-current, low-capacity measurements on conductive samples. Each kit consists of a probe tip holder, vacuum and air-side triax cabling and a vacuum feedthrough. A vacuum flange and an operator’s handbook is also included with each delivery. One kit required per MM3A.
Price On Request £0.00 Add to basket